Brooch Back, roller catch, 33mm nickel
Brooch Back, roller catch, 33mm nickel
- Quantity in stock: 320
- Product Code: 848-2041
from
$0.55
Ex Tax: $0.48
20 or more $0.47
50 or more $0.38
100 or more $0.30
Ask a Question About This Product
Description
People Also Bought
Emery Tape Sanding Cloth Strip, use for lightly roughing the surface before glueing brooch backs, ring discs etc. 100mm x 37mm strip of 320 grit fine ..
from
$0.41
Ex Tax:$0.36
Good quality Stick Pin End, nickel plate over brass.
These have a rubber insert in them so that when they are pushed onto the sharp point the..
from
$0.56
Ex Tax:$0.48
SECONDS: due to either the pin might be off the centre a bit, or the plating on the back of the pad is not perfect.
Stick Pin, nickel p..
from
$0.09 $0.45
Ex Tax:$0.08
Brooch Back, 21mm , roller catch, nickel plated.
Two holes in the back bar so the glue or solder can run through, or for stitching.
Gr..
from
$0.48
Ex Tax:$0.42
Tie Tack 10mm Pad with 11mm pin, complete unit with clutch back, silver plated over brass base. Great unit to glue your ideas on to. Not just a tie ta..
from
$1.00
Ex Tax:$0.87
Brooch Back approx. 33mm, (1.25 inch) roller catch. Antiqued brass plated. Holes in the back bar so the glue or solder can run through, or for stitchi..
from
$0.61
Ex Tax:$0.53
Charm, leaf, 15mm x 6mm.
Base metal: Iron
Finish: Antiqued copper
Sold by: Per 20 ..
from
$0.99
Ex Tax:$0.86
Shell with Pearl charm, Antique Bronze finish over cast alloy, about 15mm long, 11mm wide, 7mm thick, hole: 2mmSold by: each..
from
$0.73
Ex Tax:$0.64
Round open jump ring, very firm.
OD (outside diameter): 8mm
ID (inside diameter): 5.08mm
Wire thickness: 1.4mm
Base metal: Steel. Steel jump..
from
$18.54
Ex Tax:$16.12
Brooch Back, 1 inch, (approx 27mm), with roller catch, nickel plated. Two or three holes in the back bar so the glue or solder can run through.
Gre..
from
$0.56
Ex Tax:$0.49